TSSC 345 - Gift Card Holder

Here's my design team sample for this week's Techno Stamper Sketch Challenge. It's a gift card holder made with the envelope punch board. It's super easy to make! The stamps are from Endless Wishes. You probably recognize the rest of the supplies I used, but if not, leave me a comment and I'll reply.

  Here's the back side of the gift card holder open. You can see where I punched it with the envelope punch board.

Start with a 4.5" x 6.5" piece of designer series paper (DSP). I used the Trim The Tree Designer Series Paper Stack. These packs are cut to just the right size - no waste and no little scraps left over.

Punch 3.25" in from each side.

Score the bottom at 1.5" and fold up.

Use Fast Fuse just on the outside edges and adhere. You want to keep the adhesive at the outside edges so that the gift card can tuck down into the pocket.

Fold the top down and tuck the flap under the folded up edge (see next picture).

Crease top edge and make crisp with bone folder.

 

 Here's the back side of the gift card holder closed. See how the flap tucks into the bottom?

Here's this week's sketch. Be sure to head to the Techno Stamper Sketch Challenge site to see the rest of the design team samples and to link your entry. Hope you'll play along this week!